1.Product introduction

This is a new high-altitude lighting product of our company. It is made of high-quality aluminum profiles. The excellent heat dissipation structure allows the lamps to maintain maximum brightness and stable output. The luminaire is also equipped with high-quality reflectors, which can be used in factories, auto 4S shops, arenas and other places even if the lamps are installed at a height of 7-8 meters.

Point light source

The lamp uses a high-quality reflector to control the light angle, which makes the light more concentrated, the light is more efficient, and has anti-glare effect.

Fine spray treatment

2.Applications

Factory, automobile 4S shop, clubhouse, arena and other places where high-altitude lighting is required.

3. Specification

Different parameters

Same parameter

4.Installation and accessories

5.Matters needing attention in the use of products

(1) Avoid 1 set of switch control too many lamps, it is recommended every 1A/1 lamp, for example: 16A air switch control 16 lamps.

(2) For the first time, it is strongly recommended that all switches be in the off state, then turn on the lamp switch test one by one, and the lamp will be turned off abnormally immediately to avoid large-area failure.

(3) Avoid storing or using lamps in a humid, acid, alkali or sulfur environment.

(4) Changing the lamp board or pulling out the connection wire of the lamp board will cause the lamp chip to be damaged when the power is on.